If the shape you want is not listed, you can pick a shape close to the one you want and edit it by dragging the nodes. You can also draw your own shape by using the Draw Shape tool.
It is not possible to combine shapes, but you can edit a shape to achieve the desired area. You may also use the Draw Shape tool to create a shape from scratch.
The dimensions of very short lines are not shown.
When drawing a square or rectangular shape, turning the Snap to Grid function on or off can help.
Note that dimensions in metres are rounded to two decimal places.
Once you have drawn your area, you can select the Add Border, Add Feature or Change Paving button. This will allow you to navigate through the product menus again and select your desired product and laying pattern.
Multiple feature products can be added to a design, but it is not possible to add more than one paving or block paving product to your plan.
Once you have drawn your area and added a garden paving or block paving product you have the option to select Add Feature. This will bring up the product selection screen and you can easily select the feature you would like to add. Once selected, you can place the feature in the desired location on your plan.
To change the feature on your plan, touch in the feature area until it is highlighted. Once highlighted, touch the delete button. Now select the Add Feature button in the top navigation bar. This will then take you to the product selection screen.
It is possible to add more than one feature to your plan. Simply touch the Add Feature button and select another feature to add.
Touch the Add Border button from the top navigation bar and the select the product that you wish to add.
Touch the Add Border button from the top navigation bar and select the product that you wish to add. This will replace the existing selection. Only one border can be applied to a design.
Touching an edge on your plan will remove it and the associated product.